Forum Rule: Always post complete source code & details to reproduce any issue!
Results 1 to 4 of 4

Thread: program teensy 4.1 though pins?

Threaded View

  1. #1
    Senior Member
    Join Date
    Jan 2014
    Posts
    181

    program teensy 4.1 though pins?

    I want to mount a usb-c on a panel. I want the 5 volts to drive electronics (including Teensy).
    I want the gnd, D+, D- to program the Teensy 4.1 (not going through the micro usb connector)

    I can't use an adapter cable. Paul says "We do have USB host support for the 2nd port. And the 2nd port is easily available from either side of the PCB on 5 though-hole pins." Can I program the Teensy through wires gnd D+, D-, on the usbc going to these 3 through-hole pins?

    If so, how?

    thanks,

    Richard
    Last edited by RichardFerraro; 01-16-2021 at 02:22 PM. Reason: want to remove Teensy 4

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •