gregevans209
New member
I was planning on using a Teensy 4.1 as part of a DIY simulator setup but apparently none of the software that I as looking at using to control the setup works on the Teensy for various reasons (MMjoy2 & FreeJoy). How do I go about making the Teensy 4.1 configurable via software to change button mappings and keycodes without going into the IDE? I'm willing to code this from scratch if there's not already something I can use with the newer Teensy models otherwise I'm going to have to redo the whole project and change some circuits if I switch MCU's.
EDIT: To clarify, I want to write a GUI or command line application that allows me to remap the inputs of my controller from PC. the controller uses Joystick + Keyboard HID mode. The keyboard keycodes are primarily what need changed from pc. Similar to what MMJoy2, Freejoy, and the U-HID and Bodnar board software can do. I'm not asking for help coding the mapping software per se, but more specifically how to communicate and configure the software on the Teensy. I know how to go about doing this with standard arduino/atmel chips where the bootloader can be modified but cant figure out how to do this on the teensy where the doesnt appear to be the case.
EDIT: To clarify, I want to write a GUI or command line application that allows me to remap the inputs of my controller from PC. the controller uses Joystick + Keyboard HID mode. The keyboard keycodes are primarily what need changed from pc. Similar to what MMJoy2, Freejoy, and the U-HID and Bodnar board software can do. I'm not asking for help coding the mapping software per se, but more specifically how to communicate and configure the software on the Teensy. I know how to go about doing this with standard arduino/atmel chips where the bootloader can be modified but cant figure out how to do this on the teensy where the doesnt appear to be the case.
Last edited: