Forum Rule: Always post complete source code & details to reproduce any issue!
Page 2 of 2 FirstFirst 1 2
Results 26 to 26 of 26

Thread: Teensyduino 1.54 Beta #7

  1. #26
    Senior Member+ mjs513's Avatar
    Join Date
    Jul 2014
    Location
    New York
    Posts
    6,316
    Serial monitor seems to be hanging again similar to what happened in T4 beta testing: https://forum.pjrc.com/threads/54711...l=1#post213179

    If I run this sketch:
    Code:
    void setup() {
      // initialize serial communication at 9600 bits per second:
      Serial.begin(115200);
    }
    
    // the loop routine runs over and over again forever:
    void loop() {
      // print out the value you read:
      Serial.println(millis());
      //delay(1);        // delay in between reads for stability
    }
    the serial monitor stops output after about 1 second or so;
    Code:
    1198
    1198
    1198
    1198
    1198
    1198
    1198
    1198
    1198
    1   ---- hangs here
    If I close the SerMon on reopen same thing happens (note sketch is still running)
    Code:
    338627
    338627
    338627
    338627
    338627
    338627
    33862  - stops here after a second
    If you uncomment the delay serial monitor does not hang

    EDIT:
    I found this because I ran into the problem with a PS4 joystick dumping data to the SerMon and then hanging but PS4 was still working. If I opened up TyCommander data was still spewing to Serial. Also noticed it while testing USBHost with when dumping a large directory contents to the SerMon. Also noticed this in my DCC++ sketch.
    Last edited by mjs513; Yesterday at 02:49 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •