I'm 3D printing a life-size IG-11 robot. I'm not sure how to start the electronics part of it. here's what I'm looking to do. There are 9 small holes on the top of the head that I would like to blink randomly or different modes, (not sure if I do red LEDs or White with Red filter over holes. I'd like the head to swivel in three different parts (shown in attached photo) Not sure on mechanism to spin (lazysusan and motor). Also adding a speaker that plays random sound clips. Last thing would be a servo that tilts his eyes down and up slightly. As of right now i have the whole head printed. The very top of his head comes off. I have not separated the head for the middle two swivel points yet.
Thanks for any advice or help,
Drew
Thanks for any advice or help,
Drew