MIMXRT1062DVJ6B compatability with custom teensy PCB

[Trip]

I am not entirely sure if I want to develop a custom pcb yet for an upcoming project or just use a teensy 4.1 board instead.
But I was wondering if it is possible to use a MIMXRT1062DVJ6B instead of MIMXRT1062DVJ6A for a custom teensy 4.1 pcb with the bootloader chip from prjc.
Getting a hold of the A revision is impossible at the moment. Do any other chips from the imxrt1060 range also work in conjunction with the mkl02 chip?
The 1061 for example looks identical but it does not support the LCD/CSI/PXP interfaces. If I do not need these interfaces will it be an option to use this chip as well for a custom pcb?

 

[KurtE]

I believe this has been mentioned in a few threads.
Most recent was Paul's posting last week: https://forum.pjrc.com/threads/57132-Bootloader-Chip-For-Teensy-4-0?p=272823&viewfull=1#post272823

 

[Trip]

Ah ok I missed that thread. I see that he soldered a revision B chip onto a board but no confirmation if everything runs well.
Thank you for the response I will keep an eye on that thread as well.

 

[teosegura13]

Did you by any chance get the revision B working?

 

[Trip]

Did you by any chance get the revision B working?

We just used a teensy 4.1. it would have costed too much time in case of issues. The teensy 4.1 was put on the board as a big surface mount component. I dont think its a problem to use a B revision chip but we did not have a lot of time for this project.

 

[PaulStoffregen]

I can confirm the B version works.

 

[PaulStoffregen]

I've updated the bootloader chip page "Supported Chips" section.

https://www.pjrc.com/store/ic_mkl02_t4.html

 

[defragster]

I've updated the bootloader chip page "Supported Chips" section.

https://www.pjrc.com/store/ic_mkl02_t4.html

Safe to add the SFun T_MM 16MB Flash to the list now?

W25Q16JV*IM (Winbond)
W25Q64JV*IM (Winbond)
--128---