Hello everyone.
I'm looking at implementing a custom Teensy 3.2 board for my project and planning to buy PRJC's MKL04 chip for the bootloader. Right now, I'm copying the schematic and mapping the pinout but ran into some uncertainties.
From the image above, the value of L1 and L2 are not given. Can someone from PRJC please provide the values for them? Also what are these "termination points" that I have also circled in red? I've never seen them before in other schematics.
As for the pinout:
It states that TX & RX are pins 3 & 4 respectively and if I remember correctly, TX/RX is used in Serial.[function] in the Arduino code. But I'm sure pin 3 & 4 are not used for that. Can someone clarify that part up?
Also, I see some duplicate pins greyed out (like RX2 & TX2 on D26 and D31). Why is that there?
I'm looking at implementing a custom Teensy 3.2 board for my project and planning to buy PRJC's MKL04 chip for the bootloader. Right now, I'm copying the schematic and mapping the pinout but ran into some uncertainties.
From the image above, the value of L1 and L2 are not given. Can someone from PRJC please provide the values for them? Also what are these "termination points" that I have also circled in red? I've never seen them before in other schematics.
As for the pinout:
It states that TX & RX are pins 3 & 4 respectively and if I remember correctly, TX/RX is used in Serial.[function] in the Arduino code. But I'm sure pin 3 & 4 are not used for that. Can someone clarify that part up?
Also, I see some duplicate pins greyed out (like RX2 & TX2 on D26 and D31). Why is that there?