KurtE
Senior Member+
Hi all
For the micromod board in twowire i just changed Wire1 and Wire2 like this:
figure it would be easiest. Tried it with example2 sketch and seems to work - if anyone else want to test go for it. Going to go test on a T4 just to satisfy myself before doing a PR>
EDIT: ok tested on the i2c board and it works. Yea
It is sort of an interesting issue... Like I mentioned elsewhere.
Is Currently Wire1 on all T4.x boards is on Teensy IO pins(16 and 17) and also have some alternates on other pins.
and likewise Wire2 is on Teensy IO pins (24, 25) on all T4.x...
But the MMod as labeled 24 and 25 as SDA1 and SCL1...
Again I don't think there is a right answer here. And how far do you take it?
That is for example then:
pins 16 and 17 are listed as: TX1/A3 and RX1/A2
However 16 and 17 are currently matches other T4.x boards and is Serial4
Also on their Boards D0 and D1 are Teensy pin 4 and 5
Again I am not sure what the right answer is here!