Upon connecting my teensy 4.1 to the USB cable, it wont show up anymore as a COM7 port, not in the win10 Device manager, and not in the Arduino > Tools > Port. My teensy 3.6 and 4.0 show up immediately in both the win10 DeviceManager and in Arduino>tools>Port, with the same cable, same USB port.
I still can upload an sketch when I put the Teensy Loader automatic mode off, press the button on the Teensy 4.1, a red LED shines continuously, and press upload in Arduino. But I cannt use the serial monitor anymore.
Could it be that I fried a bit of serial-hardware on the teensy 4.1 while connecting a oscilloscope?
(win10, arduino 1.8.13, teensyduino 1.53)
I still can upload an sketch when I put the Teensy Loader automatic mode off, press the button on the Teensy 4.1, a red LED shines continuously, and press upload in Arduino. But I cannt use the serial monitor anymore.
Could it be that I fried a bit of serial-hardware on the teensy 4.1 while connecting a oscilloscope?
(win10, arduino 1.8.13, teensyduino 1.53)