Stathis_ARIS3
Member
Hi ,
I have the teensy 3.2 and when give power from 4X1.2 NiMh Battery ->4.8Volt to Vin and GND the teensy working well,when connect and disconnect the battery, the teensy starts running!
Now the problem!
When i try to use wall AC230volt to DC 12V 1000mA or batterys 2X3.6volt li-ion and after use step down to get 5 volt output and give the 5Volt to Vin and GND on teensy, not working when cut or give power from wall transformer or battery , but if cut and disconnect the cable after from step down the teensy starts running OK!
how do i get teensy to start running when connecting and disconnecting the cable before the step down?
this also happens to me in the simple code of led blinking!
Thank you!!
I have the teensy 3.2 and when give power from 4X1.2 NiMh Battery ->4.8Volt to Vin and GND the teensy working well,when connect and disconnect the battery, the teensy starts running!
Now the problem!
When i try to use wall AC230volt to DC 12V 1000mA or batterys 2X3.6volt li-ion and after use step down to get 5 volt output and give the 5Volt to Vin and GND on teensy, not working when cut or give power from wall transformer or battery , but if cut and disconnect the cable after from step down the teensy starts running OK!
how do i get teensy to start running when connecting and disconnecting the cable before the step down?
this also happens to me in the simple code of led blinking!
Thank you!!