teensy 3.2 Push button got unsoldered

Status
Not open for further replies.

pilote69

New member
Hi every body, I am using a teensy 3.2 and got my pushbutton unsoldered.

-What do you advice? Solder a new or direct solder the pins?

-Don't know if it is linked but when supplied the red led does not light anymore and is not detected by computer.

Thanks by advance.
 
Do you have a hot-air rework station? Without that it may be difficult to successfully reattach to the PCB - and
even so you'd need to be very careful about temperature as these plastic parts will not tolerate excess
air temperature.
 
Do you have a hot-air rework station? Without that it may be difficult to successfully reattach to the PCB - and
even so you'd need to be very careful about temperature as these plastic parts will not tolerate excess
air temperature.

Thanks for replying.

- Is there a way I can keep going with this board? (solder some jumper or alternative solution?)
 
Status
Not open for further replies.
Back
Top