Hi all,
I am trying to talk I2C via SCL2/SDA2 of the T4.1 but not success. The SCL2 pin is constantly low with no transitions due to I2C writes.
The setup is as follows
The documentation at https://www.pjrc.com/teensy/td_libs_Wire.html says that settings the SCL/SDA pins is supported for Teensy LC and 3 only but this doesn't make sense (?).
Any suggestions how to make SCL2/SDA2 to work?
Thanks,
Z.
I am trying to talk I2C via SCL2/SDA2 of the T4.1 but not success. The SCL2 pin is constantly low with no transitions due to I2C writes.
The setup is as follows
Code:
Wire.setSCL(24);
Wire.setSDA(25);
Wire.begin();
The documentation at https://www.pjrc.com/teensy/td_libs_Wire.html says that settings the SCL/SDA pins is supported for Teensy LC and 3 only but this doesn't make sense (?).
Any suggestions how to make SCL2/SDA2 to work?
Thanks,
Z.