Hi,
I think I killed my 2nd Teensy yesterday.
I soldered the Audio shield underneath. At that time it still works.
Then I solder the Teensy into a stripboard where `I had already soldered s bunch of buttons and connected for future componnets. Now it it wont start.
I debugged things with my n00b knowledge and only weird thing is that when I connect my multimeter in contionious mode, I get a value of 1.5 of 0.5 (depending on which probe I put where) between the VIN pin and the GND pin. A fresh Teensy just reports 1 always when I do that.
Any ideas as to what I did wrong? 2nd Teensy I ruined without really knowing what I did wrong I'm afraid it will happen again and again... Could it be the I solder too hot? Touch the pins for too long?
help much appreciated
Jeroen
I think I killed my 2nd Teensy yesterday.
I soldered the Audio shield underneath. At that time it still works.
Then I solder the Teensy into a stripboard where `I had already soldered s bunch of buttons and connected for future componnets. Now it it wont start.
I debugged things with my n00b knowledge and only weird thing is that when I connect my multimeter in contionious mode, I get a value of 1.5 of 0.5 (depending on which probe I put where) between the VIN pin and the GND pin. A fresh Teensy just reports 1 always when I do that.
Any ideas as to what I did wrong? 2nd Teensy I ruined without really knowing what I did wrong I'm afraid it will happen again and again... Could it be the I solder too hot? Touch the pins for too long?
help much appreciated
Jeroen