Hello,
I am currently using a Teensy 3.2 board, which consists of a MK20DX256VLH7 as its main MCU. I am compiling the code for it using Arduino IDE, and uploading code to it via Arduino IDE (USB).
Now I have made a new breakout board, whereby I have have removed the USB connector (and the accompanying USB communication chip - the MKL) and exposed the JTAG pins. Then I want to take the elf/hex files that have been compiled using the Arduino IDE, and then upload them to to the MK20DX256VLH7 using JTAG pins and the U-MULTILINK-FX programmer. So, how do I do this?
I have tried using MCUXpresso, but I find it very difficult to work with this. I'm getting lost in the all wizards and menus and buttons and settings.
I know this is not really a Teensy question but any help would nonetheless be much appreciated!
Many thanks!
I am currently using a Teensy 3.2 board, which consists of a MK20DX256VLH7 as its main MCU. I am compiling the code for it using Arduino IDE, and uploading code to it via Arduino IDE (USB).
Now I have made a new breakout board, whereby I have have removed the USB connector (and the accompanying USB communication chip - the MKL) and exposed the JTAG pins. Then I want to take the elf/hex files that have been compiled using the Arduino IDE, and then upload them to to the MK20DX256VLH7 using JTAG pins and the U-MULTILINK-FX programmer. So, how do I do this?
I have tried using MCUXpresso, but I find it very difficult to work with this. I'm getting lost in the all wizards and menus and buttons and settings.
I know this is not really a Teensy question but any help would nonetheless be much appreciated!
Many thanks!