Hello,
I got my black Teensy 3.6 about a month ago, and it worked pretty well, until yesterday.
I plug my Teensy into my PC, but it didn't show up in the Device Manager.
There's no COM port nor HID device detected.
While holding reset button down, insert USB cable, then release reset button.
It doesn't work.
I presume the board is dead.
The voltage was measured on a "3.3V" target using a multimeter.
It is recognized as "0.07V" as shown in the figure.
Thanks.
Is there any way to fix it?
Can I check more?
Thanks
I got my black Teensy 3.6 about a month ago, and it worked pretty well, until yesterday.
I plug my Teensy into my PC, but it didn't show up in the Device Manager.
There's no COM port nor HID device detected.
While holding reset button down, insert USB cable, then release reset button.
It doesn't work.
I presume the board is dead.
The voltage was measured on a "3.3V" target using a multimeter.
It is recognized as "0.07V" as shown in the figure.
Thanks.
Is there any way to fix it?
Can I check more?
Thanks