Is it possible to change this to this:
Code:
// GUItool: begin automatically generated code
AudioInputAnalog         adc1x(A2);      //xy=200.00001525878906,320.00000381469727
AudioAmplifier           amp1L;          //xy=389.00000762939453,341.0000057220459
AudioOutputUSB           usb2;           //xy=566.0000114440918,496.0000066757202
AudioFilterBiquad        biquad1L;       //xy=605.0000076293945,314.00000381469727
AudioAnalyzePeak         peakL;          //xy=813.0000114440918,308.00000381469727
AudioConnection          patchCord1(adc1x, amp1L);
AudioConnection          patchCord2(amp1L, 0, usb2, 0);
AudioConnection          patchCord3(amp1L, 0, usb2, 1);
AudioConnection          patchCord4(amp1L, biquad1L);
AudioConnection          patchCord5(biquad1L, peakL);
// GUItool: end automatically generated code
To this:
Code:
// GUItool: begin automatically generated code
AudioInputAnalog         adc1x(A2);       //xy=120,232.00000381469727
AudioFilterBiquad        biquad1L; //xy=321,171
AudioAmplifier           amp1L; //xy=520.0000076293945,130.00000190734863
AudioAnalyzePeak         peakL; //xy=710,122
AudioOutputUSB           usb2; //xy=726.0000076293945,317.00000286102295
//AudioOutputAnalog        dac1;           //xy=821,245
AudioConnection          patchCord1(adc1x, biquad1L);
AudioConnection          patchCord2(biquad1L, amp1L);
AudioConnection          patchCord3(amp1L, peakL);
AudioConnection          patchCord4(amp1L, 0, usb2, 0);
AudioConnection          patchCord5(amp1L, 0, usb2, 1);
//AudioConnection          patchCord6(amp1L, dac1);
// GUItool: end automatically generated code
During runtime?

in one config the Audio is pushed to Filter, then amp, then USB +PEAK
the other config it's Amp then branch to USB...then filter then peak.