I have a sketch that has some large arrays. The size of those arrays is dependent on an integer variable that is specified at the beginning of the sketch..
The sketch has been compiling and working well. I made a mistake and increased the size of that integer value. The program did not compile citing not enough memory. I reduced the integer value and recompiled. This time, the program compiled and was uploaded to the Teensy 4.1. Arduino 1.8.9 indicated the program consumed 98% of memory.
Now, I can no longer reach the board as it is not taking a com port from the computer. I powered the computer off then tried again but the board never gets a com port.
Is the board bricked? How can I fix this problem?
Thanks in advance for the community's help.
The sketch has been compiling and working well. I made a mistake and increased the size of that integer value. The program did not compile citing not enough memory. I reduced the integer value and recompiled. This time, the program compiled and was uploaded to the Teensy 4.1. Arduino 1.8.9 indicated the program consumed 98% of memory.
Now, I can no longer reach the board as it is not taking a com port from the computer. I powered the computer off then tried again but the board never gets a com port.
Is the board bricked? How can I fix this problem?
Thanks in advance for the community's help.