HI, I am using teensy 3.5 with audio shield. Plus, I added "nRF24L01 wireless module" to control some audio parameters as wireless.
I have already soldered audio shield, so I have to use different extra pins at the back side, and soldered some jumper wires as below;
pin #46(SCK), #45(MISO), #44(MOSI), #43(CSN), #42(CE)...
but this wiring gives me an error, 'radio' doesn't begin.
here is my code at the beginning part..
I think SPI pins at the back side doesn't recognize the module(nRF24L01), any help??
I have already soldered audio shield, so I have to use different extra pins at the back side, and soldered some jumper wires as below;
pin #46(SCK), #45(MISO), #44(MOSI), #43(CSN), #42(CE)...
but this wiring gives me an error, 'radio' doesn't begin.
here is my code at the beginning part..
Code:
#include <SPI.h>
#include "RF24.h"
byte adr[][6] = {"node1","node2"};
bool radioNum = 0; // 1 or 0
RF24 radio(42, 43);
I think SPI pins at the back side doesn't recognize the module(nRF24L01), any help??