kyouryoku8
Member
I need a connector for the QSPI memory I/O
tl;dr
I am working on a project which will require 48 channels of I/O. I have used the teensy 4.0 before and was looking to use the Teensy 4.1 but I am having trouble finding the hardware to connect the QSPI Memory I/O to my board.
My first thought was more headers, such [below] or similar, but when I look more into the footprint for these devices the header pads don't overlap with the QSPI Memory pads. (same pitch but different spacing)
https://www.digikey.com/en/products/detail/samtec-inc/CLM-104-02-F-D-TR/6699815
I'm happy to use a short cable to connect them as well, but I cannot find anything that matches up with the pads either.
If anyone has used these pins before I would appreciate any guidance. All I/O is low amperage and low frequency so any solution that lines up should work.
Also, if there is a way to get to the SD card terminals that may be useful in the future. I have looked for a SD card to ribbon or similar but I cannot find anything there either.
tl;dr
I am working on a project which will require 48 channels of I/O. I have used the teensy 4.0 before and was looking to use the Teensy 4.1 but I am having trouble finding the hardware to connect the QSPI Memory I/O to my board.
My first thought was more headers, such [below] or similar, but when I look more into the footprint for these devices the header pads don't overlap with the QSPI Memory pads. (same pitch but different spacing)
https://www.digikey.com/en/products/detail/samtec-inc/CLM-104-02-F-D-TR/6699815
I'm happy to use a short cable to connect them as well, but I cannot find anything that matches up with the pads either.
If anyone has used these pins before I would appreciate any guidance. All I/O is low amperage and low frequency so any solution that lines up should work.
Also, if there is a way to get to the SD card terminals that may be useful in the future. I have looked for a SD card to ribbon or similar but I cannot find anything there either.