Hey guys,
This is an issue I've been banging my head against for the last few weeks. I'm trying to control a dshot ESC with my teensy board. The project requires an update rate of 1-10 khz. I have an ESC that can handle dshot1200 apparently, but here's the problem, I don't know how to output dshot protocol bits. Frankly I'm not very good at using the buffers/shift registers, and I was hoping to find a solution. I was hoping to find a library but I haven't been able to find any.
I tried using the teensyshot library but wasn't able to get it to work. That is a potential solution if anyone wants to go using that route.
There is a cash reward, $75 and up, for anyone who manages to get my motor spinning (preferably under arduino IDE serial control)
This is an issue I've been banging my head against for the last few weeks. I'm trying to control a dshot ESC with my teensy board. The project requires an update rate of 1-10 khz. I have an ESC that can handle dshot1200 apparently, but here's the problem, I don't know how to output dshot protocol bits. Frankly I'm not very good at using the buffers/shift registers, and I was hoping to find a solution. I was hoping to find a library but I haven't been able to find any.
I tried using the teensyshot library but wasn't able to get it to work. That is a potential solution if anyone wants to go using that route.
There is a cash reward, $75 and up, for anyone who manages to get my motor spinning (preferably under arduino IDE serial control)