Adafruit Uncanny Eyes project for Teensy, help

Status
Not open for further replies.

bmklawt

New member
Hello,

First time poster, new to this and have never tried anything like this before.
I built the uncanny eyes using these instructions https://learn.adafruit.com/eye-of-newt/introduction but the screen doesn't come on and I don't know if its a hardware or software issue, this is my first time ever using Arduino IDE or any type of programming for that matter.
I have been over the hard and believe it is all correct but can't be positive I did the soft ware right, i am using Arduino 1.8.13, Teensy loader 1.55, when I looked in the Arduino library these were already installed, Adafruit_GFX, Adafruit_BusIO, Adafruit_SSD1351. I'm not sure what other info you might need to be able to help me out.

Your help is greatly appreciated
Bruce
 

Attachments

  • Arduino.jpg
    Arduino.jpg
    105.9 KB · Views: 52
  • IMG_1998.jpg
    IMG_1998.jpg
    117.9 KB · Views: 48
  • IMG_1999.jpg
    IMG_1999.jpg
    137.3 KB · Views: 47
I don't think Teensyduino 1.55 will work with Arduino 1.8.13 (which is rather old anyway).
Do a clean install of the latest version of Arduino 1.8.16 and then install Teensyduino 1.55 over that.

Pete
 
Status
Not open for further replies.
Back
Top