pepsiplease69
Member
Hi,
I was trying to desolder some header pins from my Teensy++ and a resistor(?) that was very close to the header also got removed.
I haven't tried to use the board after this but I'm pretty sure I'm going to run into issues.
The picture above is a screenshot from the Teensy++ product page. But on my board the resistor is almost touching the GND (unmarked pin) and AREF ('R' pin).
Is there anything I should do at this point? or just try using it as is? I don't have the ability to do surface mount work because it just too tiny.
I'm trying to use the teensy to run QMK software to use as a controller for a keyboard.
Thanks
I was trying to desolder some header pins from my Teensy++ and a resistor(?) that was very close to the header also got removed.
I haven't tried to use the board after this but I'm pretty sure I'm going to run into issues.
The picture above is a screenshot from the Teensy++ product page. But on my board the resistor is almost touching the GND (unmarked pin) and AREF ('R' pin).
Is there anything I should do at this point? or just try using it as is? I don't have the ability to do surface mount work because it just too tiny.
I'm trying to use the teensy to run QMK software to use as a controller for a keyboard.
Thanks