Reques about pinout Teensy ++ and Tle5010 module.

[inigohe]

Best regards..
Someone knows the correspondence of pinout betwen tle5010 module and Teensy ++??
Im not sure were I must to place GEN pin.



Best regards from Spain.

Ignacio

 

[PaulS]

If I read the TLE5010 datasheet correctly, that GEN pin is probably the external 4 MHz chip clock input, see chapter 7 in the datasheet.
[GEN = generator?]

Paul

 

[inigohe]

Thx...then Paul I did a complete error. As I said It´s not so clear where place the correct pins!!!.
Thx, for your support mate!!!
Ignacio

 

[inigohe]

Hi...tried but fails,...dont detect the sensor.
Some idea to have success??
Ignacio

 

[PaulS]

Hi Ignacio,
No idea...but it will help if you post an updated connection diagram and share your Arduino code (see the Forum Rule on top of this page).
BTW: is your project related to Teensy 2.0 + MMjoy2 firmware = Joystick Controller?

Paul

 

[inigohe]

Solved I founded a .pdf with the pin out,https://sites.google.com/site/mmjoyproject/kontrollery-sovmestimye-bazovye-platy
Regards Ignacio