Forum Rule: Always post complete source code & details to reproduce any issue!
Results 1 to 3 of 3

Thread: USB on Teesny 4 stop working?

  1. #1
    Senior Member
    Join Date
    Jan 2019
    Posts
    128

    USB on Teesny 4 stop working?

    I have a teensy 4.0 that was working fine the day before. Connected today and i can get no usb connection. Tested another T4 and connects fine.
    The problem teensy has a sketch on it that briefly blinks upon startup, so i suspect the mcu is doing OK. But no USB

    This teensy has the powerline cut and was getting a regulated 5V power through to its 5v pin. Teensy wasn't tested on anything mechanical or anything, just some oscillioscope testing. But, USB is dead. Any thoughts?

    Btw, this is the 2nd T4 to do this very thing.

  2. #2
    Senior Member PaulStoffregen's Avatar
    Join Date
    Nov 2012
    Posts
    26,801
    The first question for a dead Teensy (or dead anything electronic) is whether it is managing to power up.

    Teensy 4 has a complex power up sequence. It's explained on this page. 3.3V power turns on in the 6th of 8 steps, so just checking whether 3.3V power is present is a pretty good check.

    If you do have 3.3V power, the next easy thing to try is pressing the button for 15 seconds to restore the default LED blink program which uses RawHID for USB communication.

  3. #3
    Senior Member
    Join Date
    Jan 2019
    Posts
    128
    15 seconds press did the trick. THanks!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •