replacing a broken micro usb connector on teensy 4.1

B

benwadub

Active member
hi, I built a midi controller for a friend but he broke the micro usb connector on the teensy 4.1, I m not sure if I can replace it using the D- and D+ under the connector and also vin and ground to wire it to an external usb connector, I read on some post that it will work and other that it won t, we need to use it to power over usb to a computer and also to communicate to pc to send and receive midi data
any help will help before he come back here to try fixing it!
thanks
 
You should be able to use those two pads under the the connector.... They should be the same signal... Not same for T4... You can then hook up to the VUSB pad and GND
 
You must log in or register to reply here.
Back
Top