Hello,
I recently bought a new teensy 3.2, and when I connected it to power, it blinked orange as it's supposed to. This satisfied me, so I soldered it onto the board I had made(it was the last piece to be soldered). Once I had done this, I plugged it in and it did not blink. I tried loading a different program, but when I pressed the program mode button on the teensy, it didn't turn on. I tried using a whole lot of different USB cords, and none worked. I desoldered it to test, and it did work, and I reset it by pressing the button down while plugging it in. So I resoldered it and tested it again with the same results.
Does anyone have any solutions for this?
Thanks a ton!
I recently bought a new teensy 3.2, and when I connected it to power, it blinked orange as it's supposed to. This satisfied me, so I soldered it onto the board I had made(it was the last piece to be soldered). Once I had done this, I plugged it in and it did not blink. I tried loading a different program, but when I pressed the program mode button on the teensy, it didn't turn on. I tried using a whole lot of different USB cords, and none worked. I desoldered it to test, and it did work, and I reset it by pressing the button down while plugging it in. So I resoldered it and tested it again with the same results.
Does anyone have any solutions for this?
Thanks a ton!