Best approach for power supplies

[SteveSFX]

Hello all

Trying to design a base PCB for my Teensy 4.1.
Needs to be 230v AC input, so my original thought was to use a couple of Vigortronix AC/DC converters such as:

https://uk.farnell.com/w/c/power-li...?brand=vigortronix&output-voltage-output-1=5v

I can add a 3.3v and a 5v one to my PCB and that gives me a pretty decent amperage base for the footprint (5v @ 1000mA and 3.3v @ 1272mA. But it does take up a lot of space.
Any other ideas?

I did think of a 230v to 12v PSU and using the little Polulu step down regs, but this doesn't save me any space (in fact, its slightly larger) and a very expensive way to do it.

https://www.pololu.com/category/131/step-down-voltage-regulators

Just wondered if anyone had any ideas. Ideally... 230v AC to 5v and 3.3v with at least an Amp per bus.

Thanks

 

[SteveSFX]

OK. I am using Vigortronix PSU modules as I know they are pretty bullet proof.

https://uk.farnell.com/w/c/power-li...?brand=vigortronix&output-voltage-output-1=5v

Any ideas how I can monitor current consumption? I can measure the voltage on an analogue pin with a voltage divider (to show on my Oled display), but no idea how I can monitor the current draw (to also display on the screen).
Can't use a coil, as it's all PCB based

 

[houtson]

https://www.adafruit.com/product/4226 - might be of interest ?

 

[SteveSFX]

Oh you top banana ... thank you. That is ideal