The following scenario was repeated a few times, with a few computer and a few Teensy devices (so it is not a one-time issue)
I connected a (fully functional) Teensy to a windows 10 computer with the latest Arduino and Teensy software and uploaded a sketch. I was asked press the program mode button and did so.
Then, the Teensy just died - it doesn't appear in the Ports section of the Device Manager, in any computer I connect it to. Instead, I just see a "unrecognized USB device" message in Windows.
It appears just dead.
I tried to reset it with the 15 seconds press, but it didn't work
When I take another Teensy, connect it to my old Win7 computer and upload the sketch, everything is fine. I take the same Teensy back to the Win10 computer and upload the same sketch - the Teensy dies.
Any advice would be appreciated!!
I connected a (fully functional) Teensy to a windows 10 computer with the latest Arduino and Teensy software and uploaded a sketch. I was asked press the program mode button and did so.
Then, the Teensy just died - it doesn't appear in the Ports section of the Device Manager, in any computer I connect it to. Instead, I just see a "unrecognized USB device" message in Windows.
It appears just dead.
I tried to reset it with the 15 seconds press, but it didn't work
When I take another Teensy, connect it to my old Win7 computer and upload the sketch, everything is fine. I take the same Teensy back to the Win10 computer and upload the same sketch - the Teensy dies.
Any advice would be appreciated!!