Forum Rule: Always post complete source code & details to reproduce any issue!
Results 1 to 3 of 3

Thread: Is there a mechanical drawing for the 3.2" ILI9341 display?

  1. #1

    Is there a mechanical drawing for the 3.2" ILI9341 display?

    I bought a 3.2" display board from PJRC. When I looked at the information page, it seems that the mechanical drawing is for the smaller 2.8" display. Is there one for the 3.2" display? I know I can measure stuff, but it would be loads better if there was a drawing. Of interest are the mounting hole sizes and spacing, and the locations of the pins. I need to fab up a better mount than the simple hex standoffs that I have now. Shortly, I need to integrate the display into a decent box for my electronic lead screw project (powered by a Teensy 4.1) that I am working on. Thanks.

  2. #2
    Senior Member PaulStoffregen's Avatar
    Join Date
    Nov 2012
    Posts
    26,548
    I added the dimensions diagram to the page.

    These displays aren't manufactured by PJRC. The info is from a 3rd party source.

  3. #3
    Quote Originally Posted by PaulStoffregen View Post
    I added the dimensions diagram to the page.

    These displays aren't manufactured by PJRC. The info is from a 3rd party source.
    Thank you very much Paul. Appreciate it. The drawing confirms some of the not quite rounded to nice metric values that I had measured. Wasn't sure if I had measurement error or not. Much better to get the information from the source!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •