Hello
I have a T3.6 board using Serial (ie USB) that works fine immediately after it is programmed. But if I unplug/replug it at the USB then it misbehaves - sometimes extra characters, sometime freezes always consistent in the misbehaviour.
I can fix it by programming again, or using Reset in TyCommander (which I think activates Hafkey reset but doesn't reprogram it), both get it working properly again. But as soon as I unplug/replug again it's back to misbehaving.
Is there anywhere I should look for the problem? It is as though it is not initialising properly when just plugged in, possibly even at the USB end.
(Teensy 3.6, Teensyduino 1.41, Arduino 1.89)
I have a T3.6 board using Serial (ie USB) that works fine immediately after it is programmed. But if I unplug/replug it at the USB then it misbehaves - sometimes extra characters, sometime freezes always consistent in the misbehaviour.
I can fix it by programming again, or using Reset in TyCommander (which I think activates Hafkey reset but doesn't reprogram it), both get it working properly again. But as soon as I unplug/replug again it's back to misbehaving.
Is there anywhere I should look for the problem? It is as though it is not initialising properly when just plugged in, possibly even at the USB end.
(Teensy 3.6, Teensyduino 1.41, Arduino 1.89)