ISO Adapter to convert 4.0 or 4.1 to Arduino Form Factor

madgrizzle

Active member
I'm working on a robot project and have a DC motor controller shield that is designed for an arduino form factor. I'm migrating my system over to ROS2 and the 8-bit arduino I'm using isn't supported. I'd like to use a teensy (either 4.0 or 4.1, I have both) and need a board to adapt it to the right form factor. I found a couple on tindie but they are way overkill for my purpose and more than I'd like to spend as I'm just trying to access a few pins. I can lay out a board and get it made, but if its already been done before, I'd rather not reinvent the wheel. Any suggestions would be appreciated.
 
Back
Top