I have the larger 3.2" ILI9341 that PJRC sells. I'd like to use the display for my electronic lead screw project. Anyone know of a source that sells bezels that might fit the display?
Really want it to cover over the hole in the chassis that the display will attached to. Got any ideas?
I'm in the process of installing the physical hardware, ie. motors and pulleys and belts on the lathe. Have designed it so the changes are reversible, should things go awry.
The wireless breadboard on my desk is starting to get flaky on me, in other words getting intermittent connections. Need to make a chassis and or carrier board for everything and hard connect everything. It is the only way it would survive on a lathe. If there was a bezel available, I'd like to accommodate it.
Really want it to cover over the hole in the chassis that the display will attached to. Got any ideas?
I'm in the process of installing the physical hardware, ie. motors and pulleys and belts on the lathe. Have designed it so the changes are reversible, should things go awry.
The wireless breadboard on my desk is starting to get flaky on me, in other words getting intermittent connections. Need to make a chassis and or carrier board for everything and hard connect everything. It is the only way it would survive on a lathe. If there was a bezel available, I'd like to accommodate it.