I installed Arduino IDE 2 today, and followed the instructions to get the Teensy loader all setup and the process went fine.
Somewhere in the process of configuring the port, turning on the terminal, choosing the 3.2 and compiling my code the IDE crashed with no warning.
I started it up again, and there was no serial port available in the menu options. I rebooted the computer assuming that the crash was holding the port open, but it's still not available (please see attached image). I can successfully get to the port in IDE 1.8
Any suggestions as to how to get my port back?
Thanks,
Somewhere in the process of configuring the port, turning on the terminal, choosing the 3.2 and compiling my code the IDE crashed with no warning.
I started it up again, and there was no serial port available in the menu options. I rebooted the computer assuming that the crash was holding the port open, but it's still not available (please see attached image). I can successfully get to the port in IDE 1.8
Any suggestions as to how to get my port back?
Thanks,