Teensy 4.1 at 2,500,000 baud rate

[Ghostdad88]

I need to communicate with an encoder at 2500000 baud rate. I'm looking into getting a teensy 4.1, but want to ensure it works at that baud before getting it. I haven't had much luck when trying to find much information online about it. Thanks.

 

[PaulS]

On this page, the following is stated:

On Teensy 4 boards, the serial ports normally are limited to 6 Mbit/sec baud rate. However, maximum baud rate can be increased to 20 Mbit/sec by reconfiguring the UART clock source.

So you should be fine.

Paul