Hey, I am trying to get the "ListFiles.ino" example from the USBHost_t36 library to work. However, it seems to get stuck somehow:
Tried both 480MBit and 12MBit mode (by modifying ehci.cpp) but no luck. I basically just soldered pin header to D+/D- and connected jumpers to a usb breakout board. 5V is supplied by external power supply. GND is shared.
Am I missing something? I read that the thickness of the usb cable is important, but could this really be the problem here?
USB2 PLL running
reset waited 6
USBHS_ASYNCLISTADDR = 0
USBHS_PERIODICLISTBASE = 2001E000
periodictable = 2001E000
port change: 11001803
connect
begin reset
port change: 11001005
port enabled
end recovery
new_Device: 12 Mbit/sec
new_Pipe
enumeration:
enumeration:
Tried both 480MBit and 12MBit mode (by modifying ehci.cpp) but no luck. I basically just soldered pin header to D+/D- and connected jumpers to a usb breakout board. 5V is supplied by external power supply. GND is shared.
Am I missing something? I read that the thickness of the usb cable is important, but could this really be the problem here?