I am playing with LoRa so two Teensy4.0s are on the IDE at the same time. The problem comes at load time when confusion reigns as to which port is to be used to upload to one of the Teensys. The correct ports are selected prior to compile/load and trying to select the correct port as directed by the loader (I presume) is too late. The only solution I have found is to unplug the "non-updating" board, select the right port and then all is well. It is a pain to have keep cycling the USB connectors!
There was a note from Paul elsewhere on the web indicating found that there were "dueling" issues between the Teensy loader and Arduino IDE when it came to port selection. I'm guessing that is still unresolved and may be the root of my problem.
Any ideas out there?
Jerry
There was a note from Paul elsewhere on the web indicating found that there were "dueling" issues between the Teensy loader and Arduino IDE when it came to port selection. I'm guessing that is still unresolved and may be the root of my problem.
Any ideas out there?
Jerry