Hey all,
Been following the audio guestbook tutorial here
using this github code
I have figured out which wires run to the handset switch and connected them directly to the G and 0 pins on the teensy board as suggested.
I open the serial monitor and I have zero change in status.
It was "sort of" working recently when the switch wires and wires to teensy were on the main board but we were seeing some kind of interference so I bypassed the board and connected the wires directly. Checking the wires with a meter, I am still seeing a change in resistance, but zero change in the Serial Monitor.
Plugging the teensy into my computer, the handset beeps when it comes online but will not respond after that.
Any suggestions? I've browsed the forum here but so far have been unable to find my answer.
Thanks!
Been following the audio guestbook tutorial here
using this github code
I have figured out which wires run to the handset switch and connected them directly to the G and 0 pins on the teensy board as suggested.
I open the serial monitor and I have zero change in status.
It was "sort of" working recently when the switch wires and wires to teensy were on the main board but we were seeing some kind of interference so I bypassed the board and connected the wires directly. Checking the wires with a meter, I am still seeing a change in resistance, but zero change in the Serial Monitor.
Plugging the teensy into my computer, the handset beeps when it comes online but will not respond after that.
Any suggestions? I've browsed the forum here but so far have been unable to find my answer.
Thanks!