Lambert Lihe
New member
Greetings everyone:
I think I may have a stupid question, but I have been searching for hours and not found a an answer yet. Hope you can help me a bit.
I am considering to switch to Teensy4.1 board due to its high speed usb performance.
I am doing a project where I have a stream of data need to be read from SPI port (about 8M/s) and then it to a Jetson Orin NX with USB-serial.
According to the website, Teensy4.1 can and only sent full-speed USB, 12 or 480 Mb/s, and will ignore the baud rate rate setting on the embedded code on Teensy board.
However, I am wondering how can I receive data on the Jetson side?(Running on Linux). Usually with UART/Serial, we set a Baud rate for it to read, but in this case, we do not have such rate. What should I do with the setting? Can this baud rate setting also be ignored, and it will automatically go to full speed as well?
Or I would need another set of library and driver? if so, where I can find them?
Thank you so much for your time.
I think I may have a stupid question, but I have been searching for hours and not found a an answer yet. Hope you can help me a bit.
I am considering to switch to Teensy4.1 board due to its high speed usb performance.
I am doing a project where I have a stream of data need to be read from SPI port (about 8M/s) and then it to a Jetson Orin NX with USB-serial.
According to the website, Teensy4.1 can and only sent full-speed USB, 12 or 480 Mb/s, and will ignore the baud rate rate setting on the embedded code on Teensy board.
However, I am wondering how can I receive data on the Jetson side?(Running on Linux). Usually with UART/Serial, we set a Baud rate for it to read, but in this case, we do not have such rate. What should I do with the setting? Can this baud rate setting also be ignored, and it will automatically go to full speed as well?
Or I would need another set of library and driver? if so, where I can find them?
Thank you so much for your time.