Recent content by butchallline

Many years ago, before getting a Mac, I started with Basic Stamp2, Arduino, etc. on Windows. I just never got around to doing these things on my Mac. I have also had problems running amateur radio software on bootcamp.

Got Teensy working on older machine, but still not on original (Mac bootcamp) machine. No other com ports in use. Device Mgr. shows only Teensy USB Serial. Will try reload of Teensy Loader+serial driver. Life intervening...standby for more (good?) news... Good & bad news: Good news: now...

Thanks Paul, here are last few lines of verbose info: (much more above this...If you need more, I can send the whole thing) 10:11:44: flash, block=4, bs=1024, auto=1 10:11:44: flash, block=5, bs=1024, auto=1 10:11:44: flash, block=6, bs=1024, auto=1 10:11:44: HID/win32: waiting for device...

Thanks, jBeale. It worked...but only once! I must have been using 3.10 instead of 3.11. So... using Win7, Arduino IDE 1.6.12, Teensyduino 3.11 beta, following instructions, I got the example blink to work one, and only one, time. After that, I got this: The red error message says: Teensy...

Thanks for the very rapid response, Kurt! However, no joy :( Downloaded hourly build but still no teensy in board manager. Tried to install Teensyduino 3.1 installer and could not get past "select arduino folder" (should be in C:\Program Files (x86)\Arduino ??) Also noticed the 3.1...

I am probably premature on this. 1. I went to www.pjrc.com/help, but found no info on 3.5/6 2. Plugged board into computer and have orange LED blinking at 1 Hz. 3. Using Arduino 1.6.12 and "boards manager", I found nothing on any teensy board. 4. May I humbly suggest a separate topic for 3.5 &...