With any of the OLED display programs, the LED normally blinks because pin 13 is used. Now when I power on the teensy the LED does not light up so I am assuming that it is fried.
I am trying to connect Freetronics 128x OLED display to my Teensy but I am getting to output to the display.
http://www.freetronics.com/products/128x128-pixel-oled-module#.Ux0RgzmSxkB
OLED Pinout:
I have display powered with 5v from the teensy.
I have DNC connected to pin 14, RST to pin 15...