Transmit / Receive Telemetry from Teensy 4.1 and XBee

[fbartos]

Hello everyone!

Looking for any guidance and/or advice on where to get started with this aspect of my build. I am wanting to take me teensy build and connect an XBee to it and have another XBee on the ground with a Yagi. Any known libraries or which Arduino function to use? Thank you in advance!

XBP9B-XCST-001 - XBee-PRO XSC S3B, 900 MHz, 250 mW, RPSMA ant connector, 9600 bps | Digi International

www.digi.com

 

[mjs513]

Take a look at this

How to set up & interface XBee Module with Arduino (Tx & Rx)

Overview In this guide, we will interface the XBee Module with Arduino & set up ZigBee communication to use it as a transmitter and receiver. ZigBee

how2electronics.com

and this

Exploring XBees and XCTU - SparkFun Learn

 

[fbartos]

Take a look at this

How to set up & interface XBee Module with Arduino (Tx & Rx)

Overview In this guide, we will interface the XBee Module with Arduino & set up ZigBee communication to use it as a transmitter and receiver. ZigBee

how2electronics.com

and this

Exploring XBees and XCTU - SparkFun Learn

Thank you! I assume I apply the same technique for the model that I am trying to get and it will just go over 900MHz instead of 2.4?

 

[mjs513]

Thank you! I assume I apply the same technique for the model that I am trying to get and it will just go over 900MHz instead of 2.4?

That is correct. Just remember its a 3.3v device.