Hi everyone. I'm looking to use a Teensy 3.0 as a USB driver for a 9-DOF sensor chip, but I don't have much experience in electronics. Are there any pitfalls I should look out for?
I'm planning on using a MPU-9150 IMU with a breakout board:
It communicates over I2C, so I assume it would be fairly straightforward to set up if I use the Wire library.
I'm planning on using a MPU-9150 IMU with a breakout board:
It communicates over I2C, so I assume it would be fairly straightforward to set up if I use the Wire library.