i think it's dead because the pc cant see it,the led is not on. the HILOW test last thing i uploaded before the teensy died. i can feel the teensy heating though
cable is fully inserted, trust me i cannot push it any further, the blue part on my cable is just bigger. Also i think the teensy is dead, i dont know how that happened so im on pause till i get a new one :(
Hello Everyone, I got my hands on the pcb and i check the wiring, with a multimeter and it is all good
Front:
Back:
All I want to do is just read and write to a simple csv file, I dont care about the parsing for now i will do that later,
I...
i did change to sd card to BUILTIN_SDCARD, i will check with the person who soldered to pcb to see if the wiring is correct, i really hope this works, should have an update by tomorrow
I dont have the pcb on me right now but it uses a flat wire connector and connects them like this schematic, i checked the wiring and it is soldered correctly,
the part i am using is this one...
I am trying to read/write to a sd card connected to the teensy using the bottom pads i have no idea how to code that, I cannot find anything online about this, I have the pcb soldered and i pretty sure it works fine i just cannot program it to...
i call it later in the setup after the everything is done, one thing i noticed is it only prints if the serial2.begin is the line before it, however is doesnt read at all
this code works fine with serial2 the problem is when i add it to my main project, it doesnt work, yet somehow when i switch to serial3 all work fine, i dont want to switch to serial 3 though
I have an Xbee connected via serial2 on teensy 3.1
This code works fine no problem
void setup() {
Serial.begin(19200);
Serial2.begin(19200);
}
void loop() {
Serial2.println("test");
delay(1000);
String message = "";
char...