Hello,
I need to connect few T3.2 boards to a RPi3. The Teensy boards (three for now but more to come ) are situated in remote locations (10-20m range).
I have some RF24 modules available but I do prefer a hard wired connection (as I run some wires for remotely powering the Teensies anyway). BTW, I don't need a high speed connection, as the T3.2 boards will only send some sensor data once per second or so.
Does anyone have any experience with such a set up? Could I use the 1-Wire protocol or the I2C one? (once again, I'm talking about 10-20m between T3.2 and RPi boards).
Thank you very much for your time.
I need to connect few T3.2 boards to a RPi3. The Teensy boards (three for now but more to come ) are situated in remote locations (10-20m range).
I have some RF24 modules available but I do prefer a hard wired connection (as I run some wires for remotely powering the Teensies anyway). BTW, I don't need a high speed connection, as the T3.2 boards will only send some sensor data once per second or so.
Does anyone have any experience with such a set up? Could I use the 1-Wire protocol or the I2C one? (once again, I'm talking about 10-20m between T3.2 and RPi boards).
Thank you very much for your time.