I understand that teensy_loader_cli is not usable for readouts.
Is/are there any hints on alternative/s to use for reading the memory content via the USB interface?
I am new to Teensy and have started to experiment with Teensy2.
The reason I wish to read memory content is to verify the result from my test program (which writes information into an array in the memory).
My assumption was that there could be a cli program for this. But there may be other ways...?
/* [B]Serial Monitor Example, Teensyduino Tutorial #3
http://www.pjrc.com/teensy/tutorial3.html
[/B]
After uploading this to your board, use Serial Monitor
to view the message. When Serial is selected from the
Tools > USB Type menu, the correct serial port must be
selected from the Tools > Serial Port AFTER Teensy is
running this code. Teensy only becomes a serial device
while this code is running! For non-Serial types,
the Serial port is emulated, so no port needs to be
selected.
This example code is in the public domain.
*/
void setup() {
Serial.begin(38400);
}
void loop()
{
Serial.println("Hello World");
delay(1000);
}
I understand that teensy_loader_cli is not usable for readouts.
Is/are there any hints on alternative/s to use for reading the memory content via the USB interface?
The reason I wish to read memory content is to verify the result from my test program (which writes information into an array in the memory).
My assumption was that there could be a cli program for this. But there may be other ways...?
I am new to Teensy and unused to ask questions in this forum.