Hi,
I am trying to get my new Teensy 3.5 to talk to my PC. I installed latest Arduino software (1.6.13) followed by the latest Teensydino software (1.32). I also installed the serial_driver software. I then connected the Teensy to the PC, which started the LED blink program on the Teensy. Additionally, the device was initially detected as Teensydino RawHID but finally goes in the HID section of hardware manager as a HID compliant device and a USB input device when windows7 is done installing drivers.
Problem is that when I try to verify an example (the first blink example) in Arduino, I get a generic error message as shown below.
I have tried changing the USB options to Serial/RawHID/MIDI with same results. Also, I still have 13GB unused ram and 75% unused CPU when the verify runs.
The same code compiles just fine if I chose the board as a Mega2560 even when my arduino board is not connected to the PC.
I feel like I am making a very basic mistake and your help in this will be appreciated.
I am trying to get my new Teensy 3.5 to talk to my PC. I installed latest Arduino software (1.6.13) followed by the latest Teensydino software (1.32). I also installed the serial_driver software. I then connected the Teensy to the PC, which started the LED blink program on the Teensy. Additionally, the device was initially detected as Teensydino RawHID but finally goes in the HID section of hardware manager as a HID compliant device and a USB input device when windows7 is done installing drivers.
Problem is that when I try to verify an example (the first blink example) in Arduino, I get a generic error message as shown below.
I have tried changing the USB options to Serial/RawHID/MIDI with same results. Also, I still have 13GB unused ram and 75% unused CPU when the verify runs.
The same code compiles just fine if I chose the board as a Mega2560 even when my arduino board is not connected to the PC.
I feel like I am making a very basic mistake and your help in this will be appreciated.